Norcal Jeepers

Please login or register.

Login with username, password and session length
Advanced search  
Welcome to Norcal Jeepers!
Welcome to Norcal Jeepers! It looks like you're not registered yet. As a guest you are missing out on a bunch of great content that is only viewable once you register. To register, simply follow the link below and fill out some information about yourself. It only takes a few minutes!

Click here to register now!

Author Topic: Welder selection  (Read 174 times)

Edward

  • Offline Offline
  • Posts: 37
  • Location: Turlock
Welder selection
« on: January 03, 2017, 04:30:13 PM »

Has anyone had any experience with the miller 211 or Hobart 210 mig welders? Looking for a new welder this spring going to be using it to link my jeep and motor swap welding 1/4" and 3/16" majority of the time. Just not sure if they are best for what I'm looking to do and only want to buy a welder once
Logged

pdangerp

  • Supporting Member
  • Offline Offline
  • Posts: 2543
  • Location: Fair Oaks, CA
Re: Welder selection
« Reply #1 on: January 04, 2017, 08:34:10 PM »

I looked at those and have settled on the ironman 230. I haven't bought it yet, but I will.


Sent from my iPhone using Tapatalk
Logged

Edward

  • Offline Offline
  • Posts: 37
  • Location: Turlock
Re: Welder selection
« Reply #2 on: January 04, 2017, 11:27:12 PM »

I might do the same and wait for a bigger one. I don't want to end up getting one too small and have poor welds just didn't want to spend more than I have to
Logged

timatoe

  • Moderator
  • Offline Offline
  • Posts: 3355
  • Location: Grass Valley, CA
Re: Welder selection
« Reply #3 on: January 05, 2017, 04:07:57 AM »

Either of those will work fine.
Logged